precision rod, 0.5" diameter, 2.0"
Our PR series precision rods are designed to be used with our PRH precision rod holders and ARH adjustable rod holders. These support rods are cross drilled, except the PR-1.0, to accept a 3/16 hex wrench. This cross hole enables secure tightening to the device being supported. Attachment to the support rod is either by an 8-32(M4) stud on one end or by a 1⁄4-20(M6) tapped hole on the opposite end. PR precision rods come in six lengths from 1- to 12-inches and can be attached end-to-end with a set screw if greater lengths are needed. These precision support rods are compatible with CR-0.5, UC-0.5, and RTC-0.5 rod clamps.
- Stainless steel construction
- 1/4-20 and 8-32 interfaces
- Cross drilled for secure attachment
- VC versions available upon request
- RoHS compliant→
Check items to add to the cart or