|
|
Hardware
Precision Rods, 0.5 inch
Precision Rods
Our PR series precision rods are designed to be used with our PRH
precision
rod holders and ARH adjustable rod holders. These support rods are cross
drilled, except the PR-1.0, to accept a 3/16 hex wrench. This cross hole
enables secure tightening to the device being supported. Attachment to the
support rod is either by an 8-32 stud on one end or by a 1⁄4-20 tapped
hole on the opposite end.
PR precision rods come in six lengths from 1- to 12-inches and can be
attached end-to-end with a set screw if greater lengths are needed. These
precision support rods are compatible with
CR-0.5,
UC-0.5, and
RTC-0.5 rod
clamps.
|
|
| |
| |
|
 |
■ Stainless steel
construction
■ 1/4-20 and
8-32 interfaces
■ Cross
drilled for secure attachment
■ VC versions available upon request
Related Products
CR-0.5 clamp
UC-0.5 clamp
RTC-0.5 clamp |
|
| |
|
|
|
click on button for order form
Prices listed are for domestic U.S sales. International sales could be 10% higher
|
|
|
|
New Products
