Vertical 3 X 3
The MX312P is a versatile
platform for mounting a variety of hardware at any level on an isolation
table or platform. A complete set of
AS series spacers allows flexible vertical adjustment from 2.46- to 11.96-inches in
0.5-inch increments. To adjust the height of the platform, AS-1.5
and AS-2.0 series spacers are screwed together using 1⁄4-20 set screws.
The top and the base plates are attached to the four columns with 1⁄4-20
cap screws through the counterbored holes. Smaller height
adjustments are made by adding AS-.5 and AS-1.0 spacers to the top of the
These are secured by the final attachment of the top plate with long
1⁄4-20 screws that go through the top plate and short spacers.
The MX312P base plate is equipped with a unique
hold down pivot that allows secure single-bolt mounting anywhere on the
mounting surface. The top mounting surface is 3.0-inch x 3.0-inch
and has five 1⁄4-20 tapped holes for maximum mounting flexibility.
The top plate is also drilled and tapped with 1⁄4-20 holes on two sides.
These attachment points are designed to accept our
MX-APT-T top plates. These adapter plates allow the experimenter to remove
and replace equipment accurately and easily by loosening two flathead
screws. A new assembly configuration allows simpler and faster
change-out of spacers.