Controller Switch Box
Our easy to use ABCD switching
box allows control of one to four 4-axis micromanipulators by one
controller (MC2000 excluded). The basis of the design is simple
and requires only an extra controller junction box for each added
micromanipulator or motor drive group (up to four per group).
Junction boxes must be purchased separately, however this is more
cost-effective than individual handheld control units.
When used with the MC1100e controller, the user can save a "target"
location for each manipulator independent of the operation of the others
even after switching between micromanipulators. The DR1000 is also
compatible with this switching box and will allow the user to reposition
without the use of an expensive computer based controller. The
switch box comes with enough cables to attach four junction boxes, and all
connections are shielded.