Platform Translators

Manual, Crossed Roller

   The top of the MXOP and MXZP confocal platform systems are tapped with 1⁄4-20 threaded holes on 1.0-inch centers.  This 16.5" x 24.0" platform is supported by our 100cr series stages to ensure maximum stability across the entire platform and has external locks on the drive stages located on the right-hand side.  The towers supporting the 100crs are built up from MX312P platforms and pre-set to the optimum height for your microscope.  The base from the MX312P allows flexible mounting to either metric or imperial tapped isolation tables.  The center chamber receptacle fits 11cm chamber adapters and our PC-A11.  The underside of the platform is relieved to maximized clearance around condenser controls.

   The 100cr stages give these confocal platforms 1.0-inch (25mm) of travel in both the X and Y axes.  The adjustment screws for these stages come in either 20, 40, 80, or 100TPI versions.  The resolution chart in the middle left of this page will help you pick the correct pitch thread for your application.  Please specify which pitch of adjustment screw you require when ordering.  Replace -xx in the Model Number with the desired thread.